Another huge section bender leaves the factory!

Img - MAH500AC leaving the office

A mammoth MAH500AC roll bender is headed to its new home in mainland Europe this week. The 50-tonne machine was recently loaded and prepared for transport from AMOB’s headquarters, ready for its 2,500km journey.

The MAH500AC profile bender can bend up to HEB 500 H section, as well as over 500mm diameter pipe. These particular section bending rolls will be delivered into the hydropower sector – manufacturing turbine flanges for dams. On this occasion, the customer required the machine to bend 650mm wide by 100mm thick flat bar covers, which the MAH500AC does seamlessly.

Another huge section bender leaves the factory!
Rate this post